nm999
Junior Member
Posts: 27
|
Post by nm999 on Jun 29, 2004 19:08:33 GMT -5
I have a 2000 MS that I lifted with OME springs, T-bar crank, and a 2" body lift.
I have recently read somewhere that when a suspension lift is done the brake line proportioning valve needs to be adjusted.
I have the service manual for the 97 MS and it shows the valve by the rear of axle but I can't seem to find it on my 2000.
Does the ABS system have something to do with the valve not being present?
|
|
|
Post by Joel_CA on Jun 29, 2004 22:19:24 GMT -5
Load sensing proprotioning valves need to be adjusted after the suspension is lifted, however the MS does NOT have a load sensing valve. 2000 and older full size Montero's had load sensing valves located on the rear axle.
Joel, CA
|
|
nm999
Junior Member
Posts: 27
|
Post by nm999 on Jun 30, 2004 17:26:58 GMT -5
Thanks joel. The service manual is missleading because it shows a proportioning valve at the rear axle. But like I said earlier the service manual I have is for A 97 ms. Thanks again now I can stop worrying about it.
|
|