|
|
Post by montenegra on Jun 23, 2004 17:14:21 GMT -5
How do I remove all the trim in order to install an after market head unit?
Thanks
MonteNegra
|
|
|
|
Post by montenegra on Jun 23, 2004 17:25:01 GMT -5
And do I have to bypass the factory amp?
|
|
|
|
Post by Joel_CA on Jun 23, 2004 18:02:12 GMT -5
A small plastic butter knife works well  Start from by popping out both bottom corners, then work the clips loose from the top. If you have a factory INFINITY system, you can use the factory amp with your aftermarket head unit (this will save lots of time and costs in rewiring) by purchasing a DIN to RCA converter. This can be found by clicking here. Joel, CA |
|
|
|
Post by montenegra on Jun 23, 2004 22:39:01 GMT -5
Dammit. Of course I try to install after I get a reply!!! I figured out the panel popping part but of course I'm getting no sound!
I guessing I won't find that at Best Buy or Circuit City install shops right?
Hey thanks for the info though, because I was dumbfounded for a minute.
MonteNegra
|
|
|
|
Post by akramedog on Jun 26, 2004 1:08:12 GMT -5
Take it and have a shop do it, that way if they mess it up its there problem.
|
|
|
|
Post by justrockfocker on Jul 12, 2004 21:56:07 GMT -5
Is this converter just an adapter or does it do some sort of load balancing?
Another way to ask the question is: Is this dumb device?
thanks in advance.
-tom
|
|
Start from by popping out both bottom corners, then work the clips loose from the top. If you have a factory INFINITY system, you can use the factory amp with your aftermarket head unit (this will save lots of time and costs in rewiring) by purchasing a DIN to RCA converter. This can be found 