DC
Newbie
Posts: 11
|
Post by DC on Feb 27, 2002 22:30:21 GMT -5
Now if you are going that route.. Given the differ3ent tire sizes and tread wear then why not the groung to the front diff or cross member??
|
|
|
|
Post by skidplate98 on Feb 28, 2002 17:45:50 GMT -5
That will work too.  The only other way I can think of is to measure from center of hub to the inside if the wheel well. So how much space is in-between your ARB bumper and right above your MS on the sides? I know you said earlier that you welded it pack on. But It can't go higher. And I can't imagine that it is more the a 1" below your MS. And if it is, so what we will just subtract out the differance of where it was suppost to be. Steve Now if you are going that route.. Given the differ3ent tire sizes and tread wear then why not the groung to the front diff or cross member?? |
|
The only other way I can think of is to measure from center of hub to the inside if the wheel well.