Post by hank0604 on Oct 28, 2023 12:27:45 GMT -5
2000 Montero Sport 3.0. Just replaced my fuel pump and vehicle won't start afterwards. Just cranks and cranks but never starts. Getting error codes P0340 (camshaft position sensor) and P0180 (fuel temperature sensor). Since the vehicle was running prior to fuel pump replacement, I'm thinking those are symptoms of something I did during the repair, rather than pre-existing issues, though I know the P0340 will cause the no-start.
Looking back over the diagram in the factory service manual, I saw a "fuel cut-off valve" that's on top of the gas tank. When I removed the tank, I had to tip it on its side to slide it out from under the vehicle, so I'm thinking I must have triggered it. Is there a way to reset this? (Preferably without having to remove the gas tank again).
Looking back over the diagram in the factory service manual, I saw a "fuel cut-off valve" that's on top of the gas tank. When I removed the tank, I had to tip it on its side to slide it out from under the vehicle, so I'm thinking I must have triggered it. Is there a way to reset this? (Preferably without having to remove the gas tank again).