|
|
Post by Bryan858 on Feb 12, 2004 23:02:57 GMT -5
Just wondering how low it will go before it starts having problems. Anyone have any experiences? I was also wondering if you had to remove the Torsion Bar and reinstall it a lower stance? Or how low can we go by just loosining the Bars?
Ok last one, Are all 2000+ rear springs the same? ex. ES, LS, XLS. 4wd 2wd?
Any help would be great.. Thanks guys... Bryan
|
|
|
|
Post by sirlordoz on Feb 16, 2004 0:05:36 GMT -5
by adjusting the torsions u shouldnt have any problems, even if u bottom them out u should be fine, unless u are running huge wheels or something.
U dont have to take em out there is a nut on them that u trun to adjust them, just remember to ceep track of the number of times u tern it on each side so it sits strait.
as for the springs as far as i know they are all the same!
Lata
|
|
|
|
Post by Bryan858 on Feb 26, 2004 16:29:01 GMT -5
Ahh ok... Thanks for the reply buddy...
|
|
SlamedSport
Junior Member
Low Life.................
Posts: 34
|
Post by SlamedSport on Nov 18, 2004 17:27:54 GMT -5
To answer your question about how low you can go with a MS Sport, i think i have the lowest Sport, dropped a total of 7 inches all around. I dont recommend doing this cause the ride sucks.... i cut the hell out of the coils in the rear, cut the bumb stops and cranked the torsion bar all the way down. the alignment sucks, it goes out constantly and the MS pushes bad into corners, wearing out your tires quickly... i am actualy rasing it back up after 2 years of having it like this...so if you do drop it, i dont recommend going as low as i did...it looks sweet as hell, but the ride is terrible...
if you want to see a pic of it, its in the rides section under slamed sport...
|
|
|
|
Post by Joel_CA on Nov 18, 2004 21:16:17 GMT -5
You're right! You're slammed sports looks pretty sick! I suppose the ride can be worth putting up with for the looks. I'm sure you can afford to go back up a few inches without losing that aggresive look  Keep us informed on how it goes. Joel, CA |
|
|
|
Post by 00RalliartMS on Nov 25, 2004 2:58:20 GMT -5
yeah i think 3 inches is a clean drop. maybe 4...but we should look into custom shocks and suspension so it has a better ride. what do you think?
|
|
|
|
Post by 00RalliartMS on Nov 25, 2004 2:59:02 GMT -5
yeah i think 3 inches is a clean drop. maybe 4...but we should look into custom shocks and suspension so it has a better ride. what do you think? make em universal.. with adjustables and coil over... HA!!! any autoCAD experts postin? |
|
|
|
Post by stik6shift98 on Dec 24, 2004 5:42:20 GMT -5
where can u get shocks and springs
|
|
Keep us informed on how it goes.
