|
Post by Mitsuman on Aug 14, 2004 12:35:09 GMT -5
Who is running 285/75x16 tires on a 00' MS+.....Is this with or without Tbar lift and do they rub on max turn......
|
|
nm999
Junior Member
Posts: 27
|
Post by nm999 on Aug 15, 2004 11:43:17 GMT -5
I am running 285/75X16 Nitto Terra Graplers With A 2" T-Bar crank, +2" OME rear springs, and A 2" body lift.
I had these tires before the body lift and they did rub A llittle bit in the front when the suspension was fully compressed, but only when going thru dips in the road at high speeds, not when turning.
I think you could get away with running this size tire with just A T-Bar crank.
Hope this helps.
|
|
|
Post by Mitsuman on Aug 15, 2004 12:16:04 GMT -5
nm999,
Thanks for the reply. I will probaly stick with my current tire size(265/75x16) due to the fact that is the biggest that will fit in the spare tire area!
If I go with a 285, will have to get cargo rack on the roof to put spare in! I allways have to have matching spare.
|
|
|
Post by CerOf on Sept 21, 2004 9:29:30 GMT -5
nm999, Thanks for the reply. I will probaly stick with my current tire size(265/75x16) due to the fact that is the biggest that will fit in the spare tire area! Just remember that a 33" tire is only 1/2 more ground clearance. What I'd do and will do is have a 265/75R16 tire as a spare tire and run 255/85R16 tires. When I have a flat, I'll air down the 255/85R16 tires down to about 25psi and make sure the spare tire is aired up to the max inflation. This will ensure they are all the same height.
|
|