|
|
Post by dannytuned on Dec 4, 2008 20:45:52 GMT -5
|
|
|
|
Post by bdmontero on Dec 7, 2008 1:52:50 GMT -5
I dont know about the wheel well exit. It could have an ill effect on the paint and wheel well area. Also if I am not mistaken the exhaust has to be at the rear of the vehicle or far enough away as to not cause fumes to enter the vehicles interior. So you might get some unwanted attention from the fuzz.  Although good welding job and work:) I am impressed:) |
|
|
|
Post by dirtrider612 on Dec 8, 2008 21:05:08 GMT -5
i like the exhaust looks very clean, also not to sure about the wheel well exit though. but its definatly something different that you dont see.
sorry to go off topic but i like the rims you have, what kind are they? ive been looking and have not had a very easy time finding rims that fit. thanks
|
|
|
|
Post by dannytuned on Dec 8, 2008 22:14:26 GMT -5
the rims are 18" pro comp alloys not sure which series.  |
|
|
|
Post by bdmontero on Dec 8, 2008 23:19:31 GMT -5
Ya I am not trying to poop on your idea about the exhaust, Just because I don't like it does not make it a bad idea. Good imagination:)
|
|
|
|
Post by cwic on Dec 16, 2008 20:11:31 GMT -5
how long did it take you to install?
|
|
|
|
Post by dannytuned on Dec 16, 2008 21:56:48 GMT -5
how long did it take you to install? maybe 4-5 hours to install, probly 10+hrs in material roundup and prep+planning. i had to slit and weld both right and left sides near the three hole flange to get them to line up better with the collector, also had to make 2 sensor holes, b4 coating. on a side note, cwic, does yours ever die out when you put it in drive? mine did this a couple times, i chaulked it up to lack of back pressure. |
|
|
|
Post by cwic on Dec 19, 2008 15:00:09 GMT -5
had to do the same to get mine to line up the shop said. should have mentioned that but forgot. never had any prob with it dying though, and i have less back pressure as i just have a resonator. maybe cause i can adjust my fuel.
Clay
|
|
|
|
Post by purec4 on Dec 22, 2008 13:25:12 GMT -5
Kool look. As far as fumes not much different the dumping out just in front of the tire onder the body. If your door seals andwindow are up no problem. Your way keeps from getting torn off while mudding and such and your above the tire height as that shouldn't be a problem with exhaust. Just my two cents..... Oh and did you make the body lift kit?
|
|
Although good welding job and work:) I am impressed:)
